3D Scanner Match - blank measurement demo records Revision: 2026-10-16 License: CC0 1.0, original blank planning templates by 3D Scanner Match. These files contain no scanner measurements, calibrated reference or preset acceptance limit. 1. Before a demo, complete demo-plan.csv for ONE named dimension and ONE unchanged setup. State millimeters in the unit field. Record the actual model/revision, mode, software, operator, preparation, markers, alignment, processing and the reference method. 2. Record the reference value, uncertainty and its stated basis from a suitable independent method. Leaving them blank means they are not established. Do not enter 0 to stand in for an unknown amount or uncertainty. A displayed instrument resolution alone is not an uncertainty statement. 3. Agree the project limits and decision rule with the responsible person BEFORE seeing results. This template neither supplies a rule nor judges whether a reference method is adequate. 4. In demo-runs.csv, use one row per fresh capture of the same feature. Match plan_id and condition_id to the plan. Preserve raw, processed and receiving-file names and failed attempts. The three numbered blank rows are a starter; add rows as needed. Three runs do not establish a repeatability specification or a complete measurement uncertainty. 5. Keep another operator, day, calibration, preparation or processing change as a separate condition. Do not pool changed setups into one calculator series. 6. signed_difference_mm = measured_dimension_mm minus reference_mm. The CSV contains NO formulas and does not calculate or decide pass/fail. Enter a supported outcome, including insufficient evidence, with its reason. 7. For local arithmetic, enter the same reference and measured_dimension_mm values in https://3dscannermatch.com/guides/3d-scanner-accuracy/#calculate-your-demo-differences. Its results CSV is separate from this context record. It does not account for reference uncertainty or certify a scanner. 8. Keep the plan, run record, source files and the agreed decision together. A dimension on a reconstructed CAD model is a separate receiving-file check. Blank cells are unknown, not zero. All entries stay in your chosen local file; downloading a template sends no entered answers.